Finished Installing ADS-B Receiver

Jenn came out and helped me rivet the UAT antenna doubler and install the antenna.

I fabricated the antenna cable and installed it.  It routes along the bulkhead and then…

up to the stringer and forward to the receiver.  I also installed the power, ground and serial lines.

Finally, I fired it up and was able to get weather even sitting in my garage.  I only waited long enough to let the regional weather load, but you can see the storms out to the north 100-200 miles away.  You can see in the lower left corner that the regional weather is 4 minutes old and it’s still receiving.  With this done, I’m finished with the avionics (for now at least).

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.