Finished Repairing Gear Leg Fairings

| | Comments (0) | TrackBacks (0)
Fortunately, I was able to pop off the extra glass and flox mixture I used for the gear leg fairing attachment.



I then fabricated and epoxied some 0.063" aluminum strips onto the fairings. I curved the upper ends to follow the curvature of the gear legs.



I drilled some extra holes in the strips and then countersunk them so that the epoxy would flow through and help lock the strips to the fairings. After the glue cured, I sanded everything flush with the strips.



0 TrackBacks

Listed below are links to blogs that reference this entry: Finished Repairing Gear Leg Fairings.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/1110

Leave a comment

About this Entry

This page contains a single entry by Jason published on March 5, 2016 7:57 PM.

Repaired Gear Leg Fairings and Replaced Tailwheel Control Arm was the previous entry in this blog.

Wrapped up 2016 Condition Inspection is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Powered by Movable Type 4.1