Added Flanges to Landing Light Mounting Plates

| | Comments (0) | TrackBacks (0)
The weight of the landing lights could cause the mounting plate to flex. To stiffen it, I added a flange below the joint with the backing plate. It's bent to the inside so that it doesn't interfere with the light.



0 TrackBacks

Listed below are links to blogs that reference this entry: Added Flanges to Landing Light Mounting Plates.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/1103

Leave a comment

About this Entry

This page contains a single entry by Jason published on December 30, 2014 11:08 PM.

Fabricated Other Landing Light Backing Plate was the previous entry in this blog.

Added Filler Around Lens is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Powered by Movable Type 4.1