Finished Fuselage Wiring and Fabricated Flap Pushrods

I hooked up the canopy switch wires and verified the annunciator light illuminated appropriately.



I attached the ground wire to one of the canopy latch pivot block mounting bolts on the back side of the bulkhead.



I also installed a connector and some zip-tie bases in the roll bar support channel and hooked up the cabin light.



Finally, in preparation for mounting the wings this Friday, I fabricated the flap pushrods.  I cut the tubes from some 5/16" stock with 0.058" wall thickness and then drilled/tapped the ends for the 1/4"-28 bearings.