Pitot/AOA Tube Routing
I used some self-fusing silicone tape to keep the two fittings on the pitot tube from rubbing against each other or the inside of the pitot tube mount.
I also used a MS21919-DG10 clamp to route the tubes towards the spar so that they don't interfere with the aileron push tube. The DG10 has enough free play that I can slide the tubing through it if I ever need to take the pitot out. I'll have quick disconnects in the wing roots that I can disconnect to create the slack to do this.
I also used a MS21919-DG10 clamp to route the tubes towards the spar so that they don't interfere with the aileron push tube. The DG10 has enough free play that I can slide the tubing through it if I ever need to take the pitot out. I'll have quick disconnects in the wing roots that I can disconnect to create the slack to do this.
0 TrackBacks
Listed below are links to blogs that reference this entry: Pitot/AOA Tube Routing.
TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/256
Leave a comment