Drilled Control Mounts

| | Comments (0) | TrackBacks (0)
I drilled the control mounts to the aft center section.  This basically entailed laying out and drilling the top hole then bolting the mount in place and squaring it to the spar.  After clamping it in firmly in place, the other hole can be back drilled through the spar.



0 TrackBacks

Listed below are links to blogs that reference this entry: Drilled Control Mounts.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/248

Leave a comment

About this Entry

This page contains a single entry by Jason published on November 15, 2009 11:01 PM.

Started on Center Section was the previous entry in this blog.

Attached Control Sticks is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Powered by Movable Type 4.1