Deburring Wing Ribs

| | Comments (0) | TrackBacks (0)
I countersunk one more group of holes on the main spars and then took a break from that to start deburring the holes in the main ribs.  I did all of the outer sides of the holes and then used a couple of drill extensions to get the inner sides of the holes.



0 TrackBacks

Listed below are links to blogs that reference this entry: Deburring Wing Ribs.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/176

Leave a comment

About this Entry

This page contains a single entry by Jason published on August 25, 2009 11:15 PM.

Installed Stops in Tie-Down Brackets was the previous entry in this blog.

Deburred and Dimpled Wing Ribs is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Powered by Movable Type 4.1