Deburred and Dimpled Left Rear Spar

By Jason on August 27, 2009 11:13 PM | | Comments (0) | TrackBacks (0)
I deburred and dimpled the rear spar on the left wing.  The rear spar is much thicker than the ribs, so after dimpling the spar with the squeezer, I had to use the microstop countersink to make the dimples a little bit deeper so that the skin will seat fully.

I also received an order today from SteinAir with my roll servo wire and an assortment of snap bushings and grommets.

Categories:

« Deburred and Dimpled Wing Ribs | Main Index | Archives | Deburred and Dimpled Wing Ribs »

0 TrackBacks

Listed below are links to blogs that reference this entry: Deburred and Dimpled Left Rear Spar.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/178

Leave a comment

About this Entry

This page contains a single entry by Jason published on August 27, 2009 11:13 PM.

Deburred and Dimpled Wing Ribs was the previous entry in this blog.

Deburred and Dimpled Wing Ribs is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Monthly Archives

Powered by Movable Type 4.1