Fabricated Tank Attach Angles

| | Comments (0) | TrackBacks (0)
The tank attach angles had to be fabricated out of raw angle stock.  I first cut two pieces of angle to length and laid out the cuts.



The first rough cut on the bandsaw.



Both tank attach angles cut to final size and polished.



0 TrackBacks

Listed below are links to blogs that reference this entry: Fabricated Tank Attach Angles.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/130

Leave a comment

About this Entry

This page contains a single entry by Jason published on May 27, 2009 11:44 PM.

Fabricated Tank Stiffeners was the previous entry in this blog.

Drilled Tank Stiffeners is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Powered by Movable Type 4.1