Drilled Top Skins and Fit Bottom Skins

By Jason on May 20, 2009 11:13 PM | | Comments (0) | TrackBacks (0)
I got started tonight by fine tuning the lower wing clamps to the point that there is no measurable twist.  I then drilled out all of the skin holes on the top skins (~1000 holes) and this also entailed moving every cleco.

Afterward, I pulled out and attached the lower wing skins.  Here you can see the three access panels that are on the bottom of the wings to make inspecting the wing, aileron control linkage, pitot/aoa, autopilot roll servo, etc. possible.



Categories:

« Fit Top Wing Skins | Main Index | Archives | Finished Drilling Main Skins and Fit Outboard Leading Edge Skins »

0 TrackBacks

Listed below are links to blogs that reference this entry: Drilled Top Skins and Fit Bottom Skins.

TrackBack URL for this entry: http://www.jasonbeaver.com/mt/mt-tb.cgi/124

Leave a comment

About this Entry

This page contains a single entry by Jason published on May 20, 2009 11:13 PM.

Fit Top Wing Skins was the previous entry in this blog.

Finished Drilling Main Skins and Fit Outboard Leading Edge Skins is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.

Contact

Pages

Monthly Archives

Powered by Movable Type 4.1